Updated at: 03-08-2023 - By: Lucas

The Nissan Altima has a long and illustrious history, spanning five generations. The Nissan Altima is a low-cost car that is well-known for its dependability and ease of repair.

On the other hand, the Nissan Altima’s tire pressure monitoring system frequently displays an error on the dashboard. This error might come from a variety of causes, and each of these origins may necessitate a different remedy. Here’s how to clear a TPMS trouble code.

TPMS Error Nissan Altima 2013.

Pull over immediately if you observe a TPMS problem code on your dashboard. To avoid wasting time and gas, don’t wait until your next stop to fill up. Deflating or having a flat tire is a possibility that needs to be taken into account.

A flat tire puts you at risk of harming your axel, wheel, and suspension. In order to remedy these issues, it will take far more time and money than is necessary. Furthermore, if you continue driving after you should have stopped, you run the risk of losing control of your car and being involved in an accident.

If your TPMS displays an error code, follow these instructions (or lights up on the dashboard).

The safest thing to do is to stop at the side of the road or in a parking lot. 2) Turn on your hazard lights to show that you’ve come to a halt due to an emergency situation. 3) Use a tire pressure gauge to check the pressure in each tire (you should always have one in your vehicle since they are cheap and small). Check each tire to check if it appears to be low on air by looking at it from a distance. Listen for any leaking air, which should make a hissing sound when it does. 5) Proceed to the following step if there is no leak. Check your tires for uneven pressure, and try to fix it as soon as possible if necessary. After a brief period of pressure, check the tire pressure once more to make sure it’s not too high. Keeping going till it’s in line with the other tires.

Look for a gas station with an air pressure pump if the tire pressure is lower than the other tires. Take care not to drive more than a few hundred feet, depending on the pressure in your tires. A tow truck may be necessary if the pressure in your tires is low.

TPMS Error Nissan Altima 2013..

Your TPMS light will very certainly be reset if you take your car to a body shop for service. Reset the light using this method if you can fix the problem on your own.

To turn off the warning light after adjusting the tire pressure, travel at least 10 minutes at a speed greater than 16 mph. If that doesn’t work, you may want to try the brake reset procedure.

The first step is to remove the bottom dash panel to expose a number of fuses and wiring. 2) Locate the TPMS white two-pin connector. 3) Connect this wire to the chassis of your Altima and ground it. In order to start the vehicle, turn the key to the “ON” position. Press the brakes six times in quick succession. 6) The TPMS should flash if the procedure is a success. When you’ve successfully reset the TPMS light, you’ll see that your blinker will also blink. Continue on to the remaining tires and reset the sensors for each of them. 9) Keep in mind that there is a precise pattern that you MUST follow (below).

First the front left tire, then the front right tire, then the rear right tire, and finally the rear left tire is up.

To get the TPMS light back on, drive at 16 mph or faster for at least 10 minutes after completing this method. The Nissan Altima TPMS fault can be resolved by doing this procedure.

Here’s a video to show you how it’s done:

The TPMS warning indicator should now be fixed. It’s possible that you’ll need the assistance of a dealership to get rid of this light.