The TPMS light on your Hyundai Elantra might not go out right away if you just pumped the tires. To reset the tire pressure monitoring system (TPMS) on your Hyundai Elantra, look for the tire pressure reset button.
A Hyundai Elantra TPMS reset button is covered in this article, along with a step-by-step explanation on how to do it.
You Are Watching: TPMS Reset Button Hyundai Elantra Updated 12/2023
Where Is The TPMS Reset Button On A Hyundai Elantra?
The button for resetting the TPMS might be located in several places depending on the model of the vehicle. This button is normally situated beneath or to one side of the steering wheel on Hyundai Elantras. This can differ from model to model in terms of the exact location of the reset button
2011 Hyundai Elantra
The tire pressure reset button is located on the right side of the steering wheel on the 2011 Hyundai Elantra.
2013 Hyundai Elantra
The 2012 Hyundai Elantra’s TPMS reset button is located under the steering wheel. The TPMS reset button is located to the right of the steering wheel in a 2013 Hyundai Elantra.
2019 Hyundai Elantra
The TPMS can be found under the dashboard on the left side of newer models like the Hyundai Elantra 2019.
How Do You Reset The TPMS On a Hyundai Elantra?
It is possible to reset the tire pressure monitoring system in your Hyundai Elantra after you discover the TPMS.
Read More : Car Wash Soap Alternative Updated 12/2023
TPMS reset instructions for Hyundai Elantras may be found here.
- 1. Put the key in the ignition and turn to the ‘ON’ position
- 2. Do not start the car
- 3. Press and hold the TPMS reset button until the tire pressure light blinks 3 times.
- 4. Release the TPMS button
- 5. Start the car
- 6. Wait 20 minutes for the sensor to reset
Turn the ignition to the “ON” position by inserting the key into the ignition.
- Avoid starting the vehicle.
To reset your tire pressure monitoring system (TPMS), press and hold the reset button for three seconds.
The TPMS button can now be released.
- Turn on the ignition and drive away.
When the sensor has been on and off for 20 minutes, proceed to step 6.
Tire pressure monitoring systems can be reset by following these procedures. In order to keep an accurate record of your tire pressure, it’s critical that you reset your TPMS after each inflation. In the event that you need to inflate your tires, the tire pressure monitoring system will notify you by turning on the tire pressure light on.
How To Turn Off The Tire Pressure Light In The Hyundai Elantra
Tire pressure warning lights can be turned off if they continue to flash even after resetting your TPMS.
After you’ve gone a few miles with your tires inflated, the light should go out. However, in rare cases, the light will continue to shine.
Even after you’ve reset the TPMS on your Hyundai Elantra, if the tire pressure light is still on, here are some things to try:
- Start the car and drive for 10 minutes. Driving for around 10 minutes at 50 miles per hour should reset the sensor in the TPMS.
- Deflating and reinflating all the car tires (including the spare) can reset the TPMS sensor. Inflate all the tires to 3 PSI above the recommended amount – the recommended tire pressure for a Hyundai Elantra is 33 PSI – and then let all the air out. Once you have inflated all of the flat tires the TPMS should reset and the light will switch off.
- Disconnect the positive battery cable in the car engine when the car is off. Once the cable is disconnected, turn the car on and press the horn for approximately 5 seconds. Honking the horn will dispel the last of the power in the car. Reconnect the positive battery cable and the system will reset.
Read More : New Jersey Window Tint Laws Updated 12/2023
If your Hyundai Elantra’s tire pressure warning light does not go out after completing the steps outlined above, consult your owner’s manual or take your car to a mechanic for a full diagnosis and repair.
Batteries power the dashboard lights in an automobile. Your vehicle’s battery may be failing if your tire pressure warning light continues to flicker.
FAQs
What Is the Right Tire Pressure for a Hyundai?
A Hyundai Elantra’s recommended tire pressure is 33 PSI. You should check the pressure of all of your Hyundai’s tires on a regular basis because tires lose about 1 to 2 PSI every month. It is possible to keep track of the tire pressure in your vehicle using the TPMS. During the colder months, drivers should check their automobile tire pressure at least once a week.
Why Is My Tire Pressure Light on When My Tires Are Fine?
Even after the tires are fully inflated, the tire pressure light may remain illuminated. It’s possible that the TPMS has to be reset. To get the TPMS light to go out, you may need to wait 20 minutes or drive for 10 minutes above 50 mph. If you have a problem with your automobile battery, the tire pressure light may continue to blink.
Do You Need to Reset TPMS After New Tires?
After your Hyundai Elantra has been installed with new tires, you will have to re-set the TPMS. If one of your tires’ pressures drops below a preset level, the TPMS will let you know. Your Hynudai’s TPMS should be reset whenever you change tires, rotate your tires, or add air to your tires.
How Does a TPMS Work?
There are two types of tire pressure monitoring systems (TPMS): direct and indirect. There is a sensor in the wheel that measures air pressure if your automobile has a direct TPMS. Computer systems are alerted via wheel sensors when tire pressure falls by 25 percent below the required PSI level. Upon receiving this data, the car computer system will activate the dashboard tire pressure light.
The wheel speed sensors of an automobile’s Antilock Braking System (ABS) are used in an indirect TPMS. When sensors detect that the tires are moving at various rates, the computer system activates the dashboard indicator light. Tires with low pressure will roll more slowly than tires with higher pressure..
Conclusion
If you don’t maintain proper tire pressure, you’ll be putting yourself and your vehicle at risk. After you’ve inflated your tires, you’ll want to reset your tire pressure monitoring system (TPMS).
A Hyundai Elantra tire pressure monitoring system reset button is located in the center of the dashboard, and we hope this guide has helped you locate it. Hyundai Elantra owners can use this tutorial to learn how to turn off the tire pressure light in the event that it doesn’t go out on its own.
Sources: https://micdot.com
Category: Car
