This article contains affiliate links. There is no additional cost to you, and I may receive a small compensation if you make a purchase after clicking on one of my links. This is the first time in a long time that you’ve had to repair or replace a driveshaft, and you want to know why it keeps breaking or falling apart. But why do I continually destroying my drive shaft?
- Does Getting A New Transmission Reset Miles Updated 02/2024
- The Laundry Detergent That Turns Gas Into Clean Water and Power Updated 02/2024
- Can A Fuel Pump Relay Work Intermittently Updated 02/2024
- Is Motor Oil And Engine Oil The Same Updated 02/2024
- Is Driving With Two Feet Illegal In California Updated 02/2024
It is possible for a drive shaft to break for a variety of reasons, including the use of counterfeit parts, faulty installation, and so on. It’s a fact that your driveshaft will eventually wear out if left unchecked. Driveshaft repair or replacement should only be performed by a trained and experienced car mechanic; do not attempt to fix your driveshaft yourself. To put it another way, if you’ve tried to fix it on your own, and it keeps breaking down, you may not be doing it correctly. Because a bad driveshaft means you can’t drive, you must find a long-term remedy. Any of the following factors, on the other hand, could be the source of your driveshaft’s woes if a mechanic is in charge of the work.
Why Does My Drive Shaft Keep Breaking?
Because the driveshaft is not brittle, it should not shatter under severe pressure. Furthermore, no two driveshafts are alike; each automobile has its own, and if you try to use the driveshaft from another car to replace yours, it will likely fail prematurely. Why does your vehicle’s driveshaft keep breaking down so frequently?
We’ll get to them in a minute.
1. Fake/Weak Products
There are times when the workers at a mechanic shop may utilize bogus or poor (used) supplies to repair your vehicle when you bring it in for service. This may be the case with your ordeal; as a result, you must have your car serviced by a reputable shop or repair. Under typical driving circumstances, a driveshaft should endure a long time and show signs of wear before it finally breaks down (if the signs were ignored).
2. Improper Installation
When a driveshaft is not correctly installed, or the improper one is utilized for your automobiles, it is likely to survive a long time before it breaks down. As a result, incorrect installation is a likely cause of your driveshaft’s frequent failures.
3. Something Else Is Not In Good Shape
The drivetrain is made up of a variety of parts that are all interconnected by the driveshaft. A constantly failing driveshaft can be caused by a seriously damaged component of the powertrain. That being said, a mechanic should be called in to inspect all of the other parts that connect to the driveshaft.
4. Harsh Driving Conditions
Your driving style or the conditions in which you drive can also be a factor in the frequency with which your driveshafts fail. If you frequently travel on roads riddled with potholes and bumps, your car’s axle or driveshaft may begin to distort, which could eventually lead to a break.
These are the likely causes of your driveshaft’s incessant failures. After installing a good driveshaft, you need to make sure that all of the other components in the region are in good working order as well. It’s imperative that the person maintaining or replacing your vehicle’s driveshaft uses the proper u-joints.
For the “why does my drive shaft constantly breaking?” question in a nutshell. The answer is that your driveshaft may be breaking because you put a faulty or fake driveshaft or because it was improperly placed for some other reason. Before other associated components are damaged and you’re left with a more expensive fix due to a failing driveshaft, it’s best to act quickly and fix or replace it.